Sunday, November 6, 2011

Replacing the Kitchen Vent

As part of upgrading the kitchen, we have new granite countertops, and are replacing the appliances to a stainless steel finish. The next item to work on is the vent hood over the range. The current vent hood was put in 25 years ago when the house was built.



After looking at a bunch of high-end stainless steel vents, trying to get a quiet and effective unit (low sones), we settled on the Broan B30 Series, specifically model B3036SS (B30 series, 36 inches wide, in stainless steel). We ordered this thru Lowe's for $453.57. Once that was delivered, we could take out the old unit.



Unpacking the new vent, we have to remove the filters and the lights, in order to install it. The lights were the most difficult, since the catch for it is not done very well.



But once these are out of the way, we can break out the opening in the back to vent into the wall.



Strangely, this opening does not seem to be centered itself. For a 36 inch vent hood, the opening would be centered at 18 inches, but instead it runs from 14.25 to 22.75 (so centered on 18.5) But it seems to match the opening in the wall.



The main difficulty is that the cabinets have a 1.25 inch piece of trim extending below the bottom of the cabinet over the range. Since the vent hood is supported by screwing it into the cabinet above it, we added a couple of trim pieces that filled the 1.25 inches between the cabinet and the vent hood.



This allows the vent to be lifted into place, secured to these two pieces of wood, and then wired into the previous electrical supply line.



Replacing the light and filter panels, we can turn the power back on at the circuit breaker and we have a new working vent hood.

No comments:

Post a Comment